Operation is identical to:
Replacing all trims on left or right seat rail (comfort).
REMOVING AND INSTALLING/REPLACING GUIDE FOR FRONT LEFT OR RIGHT
HEAD RESTRAINT
Necessary preliminary tasks:
Remov
Pull lever forward to remove:
If necessary, lever out lower locking point (1) from rear with a
screwdriver.
Release screw (2).
If necessary, move seat fully forwards and upwards.
Fig. 4: Releas
1. General information on handling rubber seal profiles:
If seals reveal partly detached protective film on delivery, they must
not be bonded.
Store seals at 15 ºC to 25 ºC.
If, during the handling, the protective film has come off before
bonding, it can still be bonded.
Bonding at room a
REPLACING WIRING HARNESS SECTION FOR ENGINE (N62)
Necessary preliminary tasks:
Read out DME fault memory
Disconnect battery negative lead
ENGINE BONNET/HOOD in assembly position
Remove FRESH AIR DUCT on right and if necessary on left
Remove center of ASSEMBLY PARTITION WALL
Remove intake air