BMW X5: Removing And Installing/Replacing Both Seat Rails On Left Or Right
Front Seat (Normal/Electric)
Necessary preliminary tasks:
- Remove front seat.
- Remove lower strap (belt tensioner).
- Remove drive unit for longitudinal seat adjustment.
WARNING: Read and comply with safety regulations for handling airbag
modules and
pyrotechnical belt tensioners.
Improper handling can lead to triggering of the pyrotechnical seat belt
pretensioner or side airbag, resulting in injuries.
Switch off ignition!
Unlock all plug connections and disconnect.
.png)
Fig. 30: Identifying Plug Connections
Press catches (1).
Slide adjusting unit (2) for active head restraint adjustment in direction of
arrow and remove.
.png)
Fig. 31: Identifying Catches And Adjusting Unit
Release left and right screws (1).
Tightening torque 52 10 6AZ.
Remove seat rails (4) with carrier plate (3).
Release fastening elements (2) on left and right.
Remove carrier plate (3).
.png)
Fig. 32: Identifying Seat Rails With Carrier Plate
Release screws (1).
Remove holder (2) for lower strap (belt tensioner).
.png)
Fig. 33: Identifying Holder And Screws
REMOVING AND INSTALLING/REPLACING SEAT FRAME ON LEFT OR RIGHT
FRONT SEAT (NORMAL/ELECTRIC)
Necessary preliminary tasks:
- Remove front seat.
- Remove backrest frame.
- Remove both seat rails on front seat.
- Remove seat cover for front seat.
Release fastening elements (1) on left and right.
Remove component (2) on left and right.
Remove complete seat wiring harness.
.png)
Fig. 34: Identifying Fastening Elements And Components
Installation:
When replacing backrest or seat frame, break off centring hooks (1) from seat
frame.
.png)
Fig. 35: Identifying Centring Hooks
NOTE: The new seat frame part contains all the drives.
READ NEXT:
Necessary preliminary tasks:
Remove front seat.
Remove seat cover with padding for front seat.
Release screws (1).
Tip seat towards rear.
Installation:
Tightening torque 52 10 6AZ.
Fig. 36: Ide
Special tools required:
52 0 050.
Necessary preliminary tasks:
Remove rear panel on front seat backrest.
Fig. 43: Identifying Backrest Cover
Detach backrest cover (1) at bottom from backrest fr
Special tools required:
52 0 050.
Necessary preliminary tasks:
Remove front seat.
Remove rear panel on front seat backrest.
Remove inner cover on front seat.
WARNING: US/CDN front passenger s
SEE MORE:
Read contents of Body, General.
Spot-weld bonding is used on this vehicle. Observe specific procedure.
Remove or cover those vehicle components in the repair area which are
susceptible to heat or dust.
Use only approved spot-welding apparatus for repairs!
Place vehicle on straightening bench.
Fo
Air quality
General information
The air quality in the interior is improved by the
following components:
Emission tested passenger compartment.
Interior filter.
Air conditioning system to control the temperature,
air flow and recirculated-air mode.
Pre-ventilation.
Ionizer.
Fragrancing.
Aut