BMW X5: Removing And Installing/Replacing Outer Cover On Left Or Right Front Seat (Normal/Semi-Electric)
Pull lever forward to remove:
- If necessary, lever out lower locking point (1) from rear with a screwdriver.
Release screw (2).
If necessary, move seat fully forwards and upwards.
.png)
Fig. 4: Releasing Screw And Locking Point
Remove trim:
- Unclip at top edge
- Unclip at rear towards top side
- Pull on belt opening
- Unlock lugs
- Carefully remove trim towards front
Unfasten plug connection.
Replacement only:
Remove switch.
.png)
Fig. 5: Removing Trim
Installation:
Retaining clips and tabs must not be damaged.
.png)
Fig. 6: Identifying Retaining Clips And Tabs
REMOVING AND INSTALLING INNER COVER ON LEFT OR RIGHT FRONT SEAT (NORMAL/SEMI-ELECTRIC)
Operation is identical to:
Replacing inner cover on left or right front seat (normal/electric).
REPLACING LEFT OR RIGHT LUMBAR CUSHION ON FRONT SEAT (NORMAL/SEMI-ELECTRIC)
Operation is identical to:
Replacing lumbar cushion on front left or right seat (normal/electric).
REMOVING AND INSTALLING/REPLACING VALVE HOUSING FOR LEFT OR RIGHT FRONT LUMBAR SUPPORT (NORMAL/SEMI-ELECTRIC)
Operation is identical to:
Replacing valve housing for left or right front lumbar support (normal/electric).
REMOVING AND INSTALLING/REPLACING REAR PANEL ON LEFT OR RIGHT FRONT SEAT BACKREST (NORMAL/SEMI-ELECTRIC)
Operation is identical to:
Replacing rear panel on left or right front seat backrest (normal/electric).
REMOVING AND INSTALLING OR REPLACING FRONT LEFT OR RIGHT HEAD RESTRAINT (NORMAL/SEMI-ELECTRIC)
Operation is identical to:
Replacing front left or right head restraint (normal/electric).
REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT CRASH-ACTIVE HEAD RESTRAINT
WARNING: Read and comply with safety regulations for handling airbag modules and pyrotechnical belt pretensioners. Incorrect handling may result in triggering of the crash-active head restraint and thereby cause injury.
Switch off ignition!
Necessary preliminary tasks:
- Disconnect battery negative lead.
- Remove rear panel.
Unfasten plug connection (1) and disconnect.
Feed wiring harness out of backrest frame.
Lift out head restraint.
READ NEXT:
Replacing Seat Cover For Left Or Right Front Seat (Normal/Semi-Electric)
Special tools required:
52 0 050.
Necessary preliminary tasks:
Remove front seat.
Remove rear panel on front seat backrest.
Remove inner cover on front seat.
WARNING: US/CDN front passenger
Replacing Backrest Cover For Left Or Right Front Seat
(Normal/Semi-Electric)
Special tools required:
00 9 317.
52 0 050.
Necessary preliminary tasks:
Remove front seat.
Remove rear panel on front seat backrest.
Detach plug connection (1) by twisting from backrest fra
SEE MORE:
Piston With Ring And
REMOVING AND INSTALLING/REPLACING ALL PISTONS (N62TU)
Special tools required:
00 9 120
11 5 430
11 5 440
11 5 450
IMPORTANT: Re-install piston, conrod and bearing shells back in the
same position and in the same installation location.
Conrods and conrod bearing caps are denoted with the same
Removing And Installing/Replacing Left Exhaust Camshaft (N62/N62TU)
(cylinder bank 5 to 8)
Necessary preliminary tasks:
Remove servomotor for left eccentric shaft.
Remove ignition coils on cylinder bank 5 to 8.
Remove left cylinder head cover.
Remove spark plugs on cylinder bank 5 to 8.
Remove left inlet and exhaust adjustment units.
Remove slide rail (1).
