BMW X5: General Electrical System
BMW X5 (G05) 2019-2026 Service & Repair Manual / Engine / General Electrical System
- Troubleshooting
- Auxiliary Cable
- Plug Connection, Terminals
- Distribution Box, Power
- Battery
- Battery Vapor Separator
- Switch
- Horn
- Insert Holder For CIGA
- ECUs Modules
- Relays
- Windscreen Wipers
- Rear Window Wiper
- Headlight Washer System
- Window Washer System
READ NEXT:
Instructions On Starting Aid
Do not start the engine with help of starting sprays.
Preparation:
Conform with the following when starting engine with starting cable.
Ensure that jump lead wires are to appropriate cross-section s
Repairing Airbag Cables
IMPORTANT: Only repair those cables which show visible signs of damage. In
the event of
visible damage, make sure there is only one cable repair in effect after the
repair work. If no visible damage
SEE MORE:
Adjusting Timing Of Camshaft(s) (N52K)
Special tools required:
00 9 120 TORQUE ANGLE MEASURING DIAL
00 9 250 TORSION ANGLE WRENCH WITH FLEXIBLE EXTENSION
11 0 300
11 4 280
11 4 281
11 4 282
11 4 283
11 4 290
11 9 340
Necessary preliminary tasks:
Remove cylinder head cover
Remove fastener (1) in direction of arrow.
Installat
Replacing Centre Mount Gaiter
Necessary preliminary tasks:
Remove propeller shaft.
NOTE: The propeller shaft is balanced. The front and rear propeller
shafts must be
reassembled in the same position.
Detach gaiter (1) from groove (2).
Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.
Fig. 13: Identi
© 2019-2026 Copyright www.bmwx5info.com
