BMW X5: Insert Holder For CIGA
BMW X5 (G05) 2019-2026 Service & Repair Manual / Engine / General Electrical System / Insert Holder For CIGA
REMOVING AND INSTALLING/REPLACING POWER SOCKET IN STORAGE COMPARTMENT
Necessary preliminary tasks:
- Remove rear center console trim.
Unlock plug connection (1) and remove.
Press switch trim (2) out of rear center console trim (3).
Fig. 227: Pressing Switch Trim Out Of Rear Center Console Trim
Press power sockets (1) out of switch trim (2).
Fig. 228: Pressing Power Sockets Out Of Switch Trim
READ NEXT:
Removing And Installing/Replacing Control Unit For Active Front Steering
IMPORTANT: Read and comply with notes on protection against
electrostatic damage (ESD
protection)
Necessary preliminary tasks:
Disconnect battery negative lead.
Remove front left wheel arch cover
Removing And Installing (Replacing) Trailer Module
IMPORTANT: Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
Remove flap in luggage compartment panel on right.
Lift back insulat
SEE MORE:
Removing And Installing Mechanism For Rear Glass Lid
Necessary preliminary tasks:
Remove complete glass slide/tilt sunroof.
Remove glass slide/tilt sunroof lid at rear.
Remove rear drip molding.
Remove drive units with gearing.
Overview of glass lid mechanism:
Fig. 15: Identifying Glass Lid Mechanism Components
Floating roofliner mechanism
Removing And Installing/Replacing Airbag Unit
WARNING: Observe the following instructions to avoid any risk of injury
by the
airbag unit.
Comply with safety regulations for handling components with gas
generators.
Do not exert any force on the airbag unit.
Use only specified tools for releasing the airbag unit.
NOTE: Incorrect handling m
© 2019-2026 Copyright www.bmwx5info.com
