TEST REQUIREMENTS FOR HEADLIGHT VERTICAL AIM ADJUSTMENT
Car parked on level ground.
Replace faulty glass and mirrors and blackened light bulbs.
Check tire pressure and correct if necessary.
Apply
REMOVING AND INSTALLING/REPLACING LEFT HEADLIGHT
Operation is described in:
Removing and installing/replacing left headlight (adaptive headlight).
REMOVING AND INSTALLING/REPLACING RIGHT HEADLIGHT
Ope
REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT AUXILIARY
DIRECTION INDICATOR
Special tools required:
00 9 340.
WARNING: Follow instructions for handling light bulbs (exterior
lights).
Fold
Facts:
When a shock absorber is faulty on one side (leaking, noises, limit values
exceeded on the shock tester), often
both shock absorbers on the axle in question are replaced.
E32, E34, E38, E39: In the case of rear spring struts with ride-height control,
there is always a slight oil spillage
o
Necessary preliminary tasks:
Remove fresh-air grille in rear cabin.
Remove trim from rear cabin monitor base at front.
Release screws (1) and remove rear cabin monitor with holder (2).
Disconnect associated plug connections and feed out leads.
Tightening torque.
Fig. 39: Identifying Rear Ca