SEE MORE:
Special tools required:
11 4 481
Necessary preliminary tasks:
Remove cylinder head cover
Remove intermediate lever
If necessary, move eccentric shaft (1) on twin surface to minimum lift (2).
Fig. 218: Eccentric Shaft
NOTE: All bearing caps (1 and 2) of eccentric shaft are marked with
number
Fig. 28: Identifying Rear Axle Components
A wheel/chassis alignment check must be carried out after the following work:
Release of following screw/bolt connections:
Swinging arm, front/rear, to rear axle carrier
Swinging arm to integral link / wheel carrier
Integral link to wheel carrier