BMW X5: Engine Mechanical (6-Cylinder)
BMW X5 (G05) 2019-2026 Service & Repair Manual / Engine / Engine Mechanical (6-Cylinder)
- Engine, General
- Cylinder Head With Cover
- Oil Sump
- Housing Cover
- Crankshaft With Bearing
- Flywheel
- Connecting Rod With Bearing
- Piston With Rings And Pin
- V-Ribbed Belt With Tensioner / Deflect Element
- Camshaft
- Rocker Arm With Bearing Mount
- Valves With Springs
- Variable Valve Gear
- Oil Pump With Filter And Drive
- Water Pump With Drive
- Thermostat And Connections
- Intake Manifold
READ NEXT:
Engine Identification
Drive in engine numbers at marked surface with impact tool.
M47 / M47TU / M47T2
Fig. 1: M47 / M47TU / M47T2 Engine Identification
M57 / M57TU / M57T2
Fig. 2: M57 / M57TU / M57T2 Engine Identificatio
Mounting Engine On Assembly Stand (N52K)
Special tools required:
00 1 450 ASSEMBLY STAND
11 3 370
11 4 440
11 9 261
11 9 265
IMPORTANT: Aluminium screws/bolts must be replaced each time they are
released.
The end faces of aluminium
SEE MORE:
Luggage Compartment
REPLACING COMPLETE REAR LUGGAGE COMPARTMENT FLOOR (TAIL PANEL
REMOVED)
Read contents of Body, General.
Remove or cover those vehicle components in the repair area which are
susceptible to heat or dust.
Spot-weld bonding is used on this vehicle. Observe specific procedure.
Use only approved spot-w
Torque Angle Measuring Dial
Minimum set: Mechanical tools
Note: For torsion angle tightening of cylinder head bolts (all engines) And
reinforcement plate front axle carrier
E46
Series: E12, E21, E23, E24, E28, E30, E30/C, E30tou, E31, E32, E32/3, E34,
E34tou, E36, E36/2, E36/3,
E36/5, E36/7, E36/C, E36tou, E38, E38/3, E39, E
© 2019-2026 Copyright www.bmwx5info.com
