The brake system is one of the most important safety systems on any motor
vehicle. It is therefore essential to
act with utmost care when working on the brake system and to follow the
instructions b
IMPORTANT: Only brake test stands (analyzers) with test speeds of 2.5 -
6 km/h may be used.
Before driving onto the brake test stand (dynamic brake analyzer), switch off
the Hill Descent Control (HD
Special tools required:
34 1 260.
NOTE: The thickness of the outer brake pads can be determined without
removing the
wheels.
If necessary, move car until opening for brake pad wear indicator (brake pad)
can be seen through rim styling.
Insert special tool 34 1 260 through rim into opening for b
Release screws (1).
Remove centre console (1) towards top.
Installation:
Feed centre console (1) with guides into trim (2).
Version with rear cabin fan only:
Unclip ventilation grille (1).
Unclip operating unit (1).
Set down operating unit (1) in downward direction in centre console.
Lift centr