BMW X5: Rear Brakes
BMW X5 (G05) 2019-2026 Service & Repair Manual / Brakes / Brakes - Repair Instructions / Rear Brakes
- Overview Of Rear Brake
- Removing And Installing/Replacing Brake Linings On Both Rear Disc Brakes (Teves Floating Caliper)
- Removing And Installing Or Replacing Both Rear Brake Discs
- Overhauling Left Or Right Rear Brake Caliper (Brake Caliper Removed)
READ NEXT:
Overview Of Rear Brake
Fig. 40: Identifying Rear Brake Components
Brake disc
Brake caliper
Brake hose
Brake pads
Pulse generator / brake pad sensor
Brake guard plate
Checking thickness of brake pad
REMOVING AND IN
Removing And Installing/Replacing Brake Linings On Both Rear Disc
Brakes (Teves Floating Caliper)
Special tools required:
34 1 050.
34 1 280.
IMPORTANT: The brake pad wear sensor must be replaced once it has been
removed (brake
pad wear sensor loses its retention capability in the brake pad).
Removing And Installing Or Replacing Both Rear Brake Discs
Special tools required:
34 1 280.
Necessary preliminary tasks:
Remove wheels.
Remove and clean brake pads.
After completing work:
Adjusting handbrake.
Read and comply with notes on braking
SEE MORE:
Differential With Bearing
REPLACING SHAFT SEAL FOR RIGHT OUTPUT SHAFT
Special tools required:
31 4 160
Necessary preliminary tasks:
Remove right output shaft.
Lever shaft seal (1) out of bearing block with a screwdriver (2).
Fig. 117: Identifying Shaft Seal And Screwdriver
Installing shaft seal:
NOTE: The installation
System limits - Tire pressure monitor
System limits
Temperature
The tire inflation pressure depends on the tire's
temperature.
Driving or exposure to the sun will increase the
tire's temperature, thus increasing the tire inflation
pressure.
The tire inflation pressure is reduced when the
tire temperature falls again.
These circumstanc
© 2019-2026 Copyright www.bmwx5info.com
