BMW X5: Heater With Operation
BMW X5 (G05) 2019-2026 Service & Repair Manual / Heating And Air Conditioning / Heater With Operation
- Overview Of Heater/Air Conditioner Servomotors
- Removing And Installing/Replacing Heater
- Removing And Installing/Replacing Heater/Air Conditioner Fan
- Replacing Water Valve For Heater
READ NEXT:
Overview Of Heater/Air Conditioner Servomotors
Fig. 1: Identifying Heater/Air Conditioner Servomotors Components Location
Servomotor, defrosting
Servomotor, footwell, rear cabin right
Servomotor, ventilation, front right
Servomotor, stratifi
Removing And Installing/Replacing Heater
WARNING: Avoid contact with refrigerant and refrigerant oil.
Follow safety instructions for handling refrigerant R 134a.
Follow safety instructions for handling refrigerant oil.
IMPORTANT: Risk of d
Removing And Installing/Replacing Heater/Air Conditioner Fan
Necessary preliminary tasks:
Disconnect battery negative lead.
Remove lower trim from instrument panel.
Release screws (1).
Fig. 10: Identifying Heater/Air Conditioner Fan Screws
Release screws
SEE MORE:
Instructions For Removing And Installing Electronic Control Units
IMPORTANT:
Disconnecting the vehicle battery will cancel the fault memories
of control
units. Consequently, before disconnecting the car's battery, always
interrogate the fault memories. Investigate stored faults and, once any
faults have been remedied, cancel the fault memory.
Control unit
Mechanical Attachments
REPLACING SELECTOR SHAFT SEAL (GA6HP26Z)
Special tools required:
24 5 361
24 5 362
24 5 364
24 5 366
IMPORTANT: After completion of work, check transmission fluid level.
Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious damage to the
aut
© 2019-2026 Copyright www.bmwx5info.com
