BMW X5: Sunroof
- Repair Instructions For Bonded Seals
- Removing And Installing/Replacing Drive Cable Plate
- Removing And Installing Mechanism For Front Glass Lid
- Removing And Installing Mechanism For Rear Glass Lid
- Removing And Installing/Replacing Mechanism For Floating Roofliner
- Replacing Fastener For Wind Deflector On Left Or Right
- Removing And Installing Front Crossmember
READ NEXT:
Repair Instructions For Bonded Seals
1. General information on handling rubber seal profiles:
If seals reveal partly detached protective film on delivery, they must
not be bonded.
Store seals at 15 ºC to 25 ºC.
If, during the han
Removing And Installing/Replacing Drive Cable Plate
Necessary preliminary tasks:
Remove mechanism for glass cover at front.
Overview of glass lid mechanism:
Fig. 1: Identifying Glass Lid Mechanism Components
Floating roofliner mechanism
Mechani
Removing And Installing Mechanism For Front Glass Lid
Necessary preliminary tasks:
Remove glass slide/tilt sunroof.
Remove glass slide/tilt sunroof lid at front.
Remove glass slide/tilt sunroof lid at rear.
Remove front drip molding.
Remove driv
SEE MORE:
N52KP And N51 Fuel System
The N52KP and N51 engine continue to use the conventional "manifold
injection" system carried over from the N52. The fuel supply components are also
carried over with regard to the EKP module, fuel pump etc.
Fig. 50: Identifying Fuel Supply System
N54 Engine
The N54 engine uses the new High Preci
Replacing Cover For Longitudinal Member With Left Door Pillar
(Partial Replacement B - Pillar)
Read contents of Body, General.
Spot-weld bonding is used on this vehicle. Observe specific procedure.
Remove or cover those vehicle components in the repair area which are
susceptible to heat or dust.
Use only approved spot-welding apparatus for repairs!
Place vehicle on straightening bench.
Fo
© 2019-2026 Copyright www.bmwx5info.com
