BMW X5: Removing And Installing Front Crossmember
Necessary preliminary tasks:
- Remove glass slide/tilt sunroof.
- Remove drive.
Release screws in marked area.
Tightening torque: 54 12 03AZ.
Remove crossmember (1).
If necessary, release fabric adhesive tape and replace.
Installation:
Pitch cables must be correctly located in guide
.png)
Fig. 37: Identifying Crossmember
REMOVING AND INSTALLING REAR CROSSMEMBER
Necessary preliminary tasks:
- Remove glass slide/tilt sunroof.
- Remove drive.
Release screws in marked area.
Tightening torque: 54 12 03AZ.
Remove crossmember (1).
Installation:
Pitch cables must be correctly laid diagonally in guide.
.png)
Fig. 38: Identifying Crossmember
READ NEXT:
NOTE: Initialization comprises:
Normalization
Learning characteristic curve
The mechanical end positions are recorded and stored during normalization.
The characteristic curve is learned immediat
Special tools required:
51 3 057.
Fig. 43: Identifying Special Tools (51 3 057)
Insert special tool 51 3 050 TOOL in spring (1).
Using a suitable tool (2), unlock catch (3) of fastener for wind d
SEE MORE:
Overview
Buttons in the vehicle
Climate control functions
Temperature.
Maximum cooling.
AUTO program.
Air flow, manual.
Intensity Auto program.
Air distribution, manual.
Seat heating.
Switching climate control
functions on/off
Functional requirement
The rear automatic climate control is not ready
REMOVING AND INSTALLING/REPLACING INTAKE FILTER HOUSING (N52K)
Necessary preliminary tasks:
Switch off ignition
Lever out expansion rivets (1).
Press lock (2) and raise intake duct (3).
Detach intake duct (3) from air filter housing and remove.
Fig. 8: Identifying Expansion Rivets, Lock And Int