BMW X5: Start/Stop button
Principle
.png)
Pressing the Start/Stop button
switches drive-ready state on or
off.
Drive readiness is switched on when you depress the brake pedal while pressing the Start/Stop button.
Pressing the Start/Stop button again switches the drive-ready state back off and standby state is switched back on.
Additional information:
- Drive-ready state
- Standby state
Driving away
1. Turn on drive readiness.
2. Apply gear position.
3. Release the parking brake.
4. Drive away.
READ NEXT:
Auto Start/Stop function
Principle
The Auto Start/Stop function helps save fuel.
The system switches off the engine during a
stop, for instance in traffic jam or at traffic lights.
Drive-ready state remains switched on. The
Driving Dynamics Control
Principle
The Driving Dynamics Control influences the
driving dynamics properties of the vehicle.
The vehicle can be adjusted depending on the
situation using various driving modes.
General informati
Parking brake
Principle
The parking brake is used to prevent the vehicle
from rolling when it is parked.
Safety information
Warning
An unsecured vehicle can begin to move and
possibly roll away. There is a risk of
SEE MORE:
Mufflers
REPLACING REAR MUFFLER (N62TU)
Special tools required:
00 2 210
31 2 220
WARNING: Scalding hazard!
Only perform these tasks after exhaust system has cooled down.
Support exhaust system with special tool 31 2 220.
Fig. 8: Identifying Special Tool (31 2 220)
NOTE: If the cutting lines are not ide
Removing And Installing Or Replacing Left Output Shaft
Special tools required:
31 4 170
Remove front wheel.
IMPORTANT: Expand turning lock sufficiently to avoid damaging thread
when releasing collar nut.
Release collar nut (1), press brake pedal to floor for this purpose.
Fig. 140: Identifying Collar Nut
Remove left microfilter housing cover.
IMPOR
© 2019-2026 Copyright www.bmwx5info.com
