BMW X5: Removing And Installing/Replacing Drip Molding
Necessary preliminary tasks:
- Remove complete glass slide/tilt sunroof.
- Remove glass slide/tilt sunroof lid at rear.
- Remove glass slide/tilt sunroof lid at front.
IMPORTANT: Risk of damage to drip molding carrier.
Carefully unclip drip molding (1) upwards out of carrier (2).
.png)
Fig. 65: Uncoupling Drip Molding
Installation:
Attach spring (3) to drip molding pivot point.
Make sure spring is correctly positioned in drip molding.
.png)
Fig. 66: Locating Spring
Installation:
Observe installation sequence:
- Suspend spring in drip molding carrier
- Press drip molding onto glass slide/tilt sunroof
- Clip pivot point (bearing) of drip molding into carrier
Check drip molding for spring tension.
.png)
Fig. 67: Pressing Drip Molding Onto Glass Slide/Tilt Sunroof
REMOVING AND INSTALLING/REPLACING REAR DRIP MOLDING
Necessary preliminary tasks:
- Remove complete glass slide/tilt sunroof.
- Remove glass slide/tilt sunroof lid at rear.
Unlock tab (2) and remove drip molding (1) towards top.
NOTE: 2 springs are loosely connected to guide for drip molding.
Installation:
Make sure springs are reinstalled on drip molding carriers.
.png)
Fig. 68: Locating Drip Molding And Tab
Removing drip molding carrier:
NOTE: Drip molding carrier cannot be removed without incurring damage.
Break out tabs with a screwdriver and lever out carrier.
Installation:
Replace drip molding carrier and hook into place.
.png)
Fig. 69: Identifying Tabs
REMOVING AND INSTALLING FRONT CROSSMEMBER
Necessary preliminary tasks:
- Remove glass slide/tilt sunroof.
- Remove drive.
Release screws in marked area.
Tightening torque: 54 12 03AZ.
Remove cross-member (1).
If necessary, release fabric adhesive tape and replace.
Installation:
Pitch cables must be correctly located in guide
.png)
Fig. 70: Identifying Crossmember
REMOVING AND INSTALLING REAR CROSSMEMBER
Necessary preliminary tasks:
- Remove glass slide/tilt sunroof.
- Remove drive.
Release screws in marked area.
Tightening torque: 54 12 03AZ.
Remove cross-member (1).
Installation:
Pitch cables must be correctly laid diagonally in guide.
.png)
Fig. 71: Identifying Crossmember
READ NEXT:
Danger Of Poisoning If Oil Is Ingested/Absorbed Through The Skin
Danger of poisoning!
Ingesting oil or absorbing through the skin may cause poisoning!
Possible symptoms are:
Headaches
Dizziness
Stomach aches
Vomiting
Diarrhoea
Cramps/fits
Unconsciousness
P
SEE MORE:
Clearance And Side
REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT SIDE MARKER
Special tools required:
00 9 323.
Necessary preliminary tasks:
Remove front wheel arch cover front section.
NOTE: Minimum object temperature of side marker and side panel > or =
18 ºC.
If this temperature is not achieved,
Removing And Installing Outer Upper Rail Trim With Electric Anchor Fitting
Tensioner (From 04/2004)
Driver's seat only:
NOTE: Version with anchor fitting tensioner from 04/2004.
Lever trim (3) out of seat mechanism:
upwards,
slide towards rear
and feed out of anchor fitting tensioner.
Installation:
Secure plug connection with felt strip against unlocking.
Lock on plug connection to anchor fit
