BMW X5: Danger Of Poisoning If Oil Is Ingested/Absorbed Through The Skin
Danger of poisoning!
Ingesting oil or absorbing through the skin may cause poisoning!
Possible symptoms are:
- Headaches
- Dizziness
- Stomach aches
- Vomiting
- Diarrhoea
- Cramps/fits
- Unconsciousness
Protective measures/rules of conduct:
- Pour oil only into appropriately marked containers
- Do not pour oil into drinking vessels (drinks bottles, glasses, cups or
mugs)
- Observe country-specific safety regulations
First aid measures:
- Do not induce vomiting.
If the person affected is still conscious, he/she must rinse out their mouth
with water, drink plenty of
water and consult a doctor immediately.
If the person affected is unconscious, do not administer anything by mouth,
place the person in the
recovery position and seek immediate medical attention.
RISK OF INJURY IF OIL COMES INTO CONTACT WITH EYES AND SKIN
Danger of injury!
Contact with eyes or skin may result in injury!
Possible symptoms are:
- Impaired sight
- Irritation of the eyes
- Reddening of the skin
- Rough and cracked skin
Protective measures/rules of conduct:
- Wear protective goggles
- Wear oil-resistant protective gloves
- Observe country-specific safety regulations
First aid measures:
- Eye contact: Rinse eyes immediately with plenty of water for at least 15
minutes; if available, use an eye-rinsing
bottle. If irritation of the eyes persists, consult a doctor.
- Skin contact: Wash off with soap and water immediately. If irritation
persists, consult a doctor.
NOTE: Do not use solvents/thinners.
READ NEXT:
WARNING: Danger of poisoning if oil is ingested/absorbed through the
skin!
Recycling:
Observe country-specific waste-disposal regulations.
Measures if oil is unintentionally released:
Personal pre
NOTE: Vertical acceleration sensor adjustment must be performed after
replacement of
the spring strut/shock absorber with damper satellites.
Connect vehicle to BMW diagnosis system.
Select and perfo
NOTE: The Service function Initial operation of Dynamic Drive must be
carried out
after:
Work on the Dynamic Drive system which involved opening hydraulic
lines
Replacement / Programming / Codin
SEE MORE:
Special tools required:
00 5 010
32 1 060
33 1 308
33 5 130
33 5 140
Necessary preliminary tasks:
Remove rear differential.
Withdraw shaft seal with special tools 00 5 010 and 32 1 060 / 33 1 308.
Fig. 27: Identifying Special Tools (00 5 010 ), (32 1 060) And (33 1 308)
Installing new sha
Display on the Control Display
Overview
Toolbar, left
Camera image
Side view
Automatic camera perspective
Movable unobstructed camera perspective
Toolbar, right
Rearview camera
Selection window
Toolbar on the left
The left toolbar can be used for the direct selection
of various views via