BMW X5: Output Shaft
BMW X5 (G05) 2019-2026 Service & Repair Manual / Front Axle / Output Shaft
- Replacing Shaft Seal For Left Output Shaft
- Replacing Shaft Seal For Right Output Shaft
- Notes On Removing And Installing Low Profile Band Clamps
- Pressing Output Shaft Out Of Drive Flange (Wheel Hub) And Drawing In
- Removing And Installing Or Replacing Left Output Shaft
READ NEXT:
Replacing Shaft Seal For Left Output Shaft
Special tools required:
31 4 160
Necessary preliminary tasks:
Remove left output shaft.
Lever shaft seal (1) out of front differential with a screwdriver (2).
Fig. 122: Identifying Shaft Seal A
Replacing Shaft Seal For Right Output Shaft
Special tools required:
31 4 160
Necessary preliminary tasks:
Remove right output shaft.
Lever shaft seal (1) out of bearing block with a screwdriver (2).
Fig. 125: Identifying Shaft Seal And S
Notes On Removing And Installing Low Profile Band Clamps
Special tools required:
31 5 200
IMPORTANT: During removal Low Profile band clamp (dotted line) is
overstretched and must
not be reused!
Fig. 128: Identifying Clamp
Removing:
Place special tool 3
SEE MORE:
Replacing Complete Rear Left Wheel Arch (Rear Left Side Panel
Removed)
Read contents of Body, General.
Spot-weld bonding is used on this vehicle. Observe specific procedure.
Remove or cover those vehicle components in the repair area which are
susceptible to heat or dust.
Use only approved spot-welding apparatus for repairs!
Place vehicle on straightening bench.
Fo
Instructions On Starting Aid
Do not start the engine with help of starting sprays.
Preparation:
Conform with the following when starting engine with starting cable.
Ensure that jump lead wires are to appropriate cross-section size.
Only use fuse-protected jump leads.
Check whether the current supplying battery has 12 V volt
© 2019-2026 Copyright www.bmwx5info.com
