BMW X5: Danger Of Poisoning If Oil Is Ingested/Absorbed Through The Skin

Danger of poisoning!

Ingesting oil or absorbing through the skin may cause poisoning! Possible symptoms are:

• Headaches
• Dizziness
• Stomach aches
• Vomiting
• Diarrhoea
• Cramps/fits
• Unconsciousness

Protective measures/rules of conduct:

• Pour oil only into appropriately marked containers
• Do not pour oil into drinking vessels (drinks bottles, glasses, cups or mugs)
• Observe country-specific safety regulations

First aid measures:

• Do not induce vomiting.

  If the person affected is still conscious, he/she must rinse out their mouth with water, drink plenty of water and consult a doctor immediately.

  If the person affected is unconscious, do not administer anything by mouth, place the person in the recovery position and seek immediate medical attention.

RISK OF INJURY IF OIL COMES INTO CONTACT WITH EYES AND SKIN

Danger of injury!

Contact with eyes or skin may result in injury!

Possible symptoms are:

• Impaired sight
• Irritation of the eyes
• Reddening of the skin
• Rough and cracked skin

Protective measures/rules of conduct:

• Wear protective goggles
• Wear oil-resistant protective gloves
• Observe country-specific safety regulations

First aid measures:

• Eye contact: Rinse eyes immediately with plenty of water for at least 15 minutes; if available, use an eye-rinsing bottle. If irritation of the eyes persists, consult a doctor.
• Skin contact: Wash off with soap and water immediately. If irritation persists, consult a doctor.

NOTE: Do not use solvents/thinners.

SAFETY INSTRUCTIONS FOR HANDLING OIL

WARNING: Danger of poisoning if oil is ingested/absorbed through the skin!

Risk of injury if oil comes into contact with eyes and skin!

Recycling:

Observe country-specific waste-disposal regulations.

Measures if oil is unintentionally released:

• Personal precautionary measures: Danger of slipping! Keep non-involved persons away from the work area. Wear personal protective clothing/equipment.
• Environmental protection measures: Prevent oil from draining into drain channels, sewerage systems, pits, cellars, water and the ground.
• Limiting spread: Use oil blocks to prevent the surface spread of oil.
• Cleaning procedure: Bind and dispose of escaped oil with nonflammable absorbents.

ENGINE OIL SERVICE (N62/N62TU)

Recycling:

Catch and dispose of used oil.

Observe country-specific waste-disposal regulations.

NOTE: For purposes of clarity, this work step is shown without the reinforcement plate.

Open oil drain plug (1) in oil sump.

Remove oil drain plug (2) on oil filter cap (3).

Release oil filter cover (3).

Fig. 1: Identifying Oil Drain Plug, Oil Filter Cap And Oil Filter Cover

Installation:

Replace and lubricate sealing rings (1 and 2).

Replace oil filter element (3) and slide into oil filter cover.

Oil filter element (3) must snap audibly into place.

Fig. 2: Identifying Sealing Rings And Oil Filter Element

Installation:

Replace sealing ring.

Install oil drain plug (1) and tighten down.

Tightening torque 11 13 1AZ.

Insert and tighten down oil filter cover (3).

Tightening torque 11 42 2AZ.

Insert oil drain plug (2) on oil filter cap (3) and tighten down.

Tightening torque: 10 Nm.

Fig. 3: Identifying Oil Drain Plug, Oil Filter Cap And Oil Filter Cover

Pour in engine oil.

Start engine and run at idle until oil indicator lamp goes out.

Switch off engine, wait approx. 5 minutes and then check engine oil level.

Top up engine oil if necessary.

READ NEXT: