BMW X5: Fuel Pump
- Removing And Installing Or Replacing Fuel Gauge Sensor (Petrol/Gasoline, Right)
- Removing And Installing Or Replacing Fuel Gauge Sensor (Petrol/Gasoline, Left)
- Removing And Installing/Replacing Fuel Pump (Petrol/Gasoline Vehicles)
READ NEXT:
Removing And Installing Or Replacing Fuel Gauge Sensor (Petrol/Gasoline,
Right)
Recycling
Fuel escapes when fuel lines are detached. Have a suitable collecting
container ready.
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
IMPORTANT: E
Removing And Installing Or Replacing Fuel Gauge Sensor
(Petrol/Gasoline, Left)
Recycling
Fuel escapes when fuel lines are detached. Have a suitable collecting
container ready.
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
IMPORTANT:
Removing And Installing/Replacing Fuel Pump (Petrol/Gasoline
Vehicles)
Special tools required:
00 9 252
Recycling
Fuel escapes when fuel lines are detached. Have a suitable collecting
container ready.
Catch and dispose of escaping fuel.
Observe country-specific was
SEE MORE:
Stamping Vehicle Identification Number
Special tools required:
41 0 000
41 1 190
41 1 191
41 1 192
NOTE: If the stamped vehicle identification number is removed during
repair work, it
must be stamped in again.
Read and comply with General Information.
Necessary preliminary tasks:
Remove front right spring strut.
Special tool k
Replacing Centre Mount Gaiter
Necessary preliminary tasks:
Remove propeller shaft.
NOTE: The propeller shaft is balanced. The front and rear propeller
shafts must be
reassembled in the same position.
Detach gaiter (1) from groove (2).
Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.
Fig. 13: Identi
© 2019-2026 Copyright www.bmwx5info.com
