BMW X5: Fuel Filter
REPLACING FUEL FILTER (M57T2)
Necessary preliminary tasks:
- Switch off ignition
- Remove rear assembly underside protection
Recycling:
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
Release clamps (1).
Pull off hose.
Pull out retainer (2).
Detach fuel preheater (3) in direction of arrow.
Remove fuel filter.
Installation:
Modify retaining clamp.
Add final details to vehicle.
Installation:
Venting fuel system:
Vent fuel system with BMW diagnosis tester.
READ NEXT:
Injection Nozzle And Lines
REPLACING COMPLETE INJECTION PIPE (N52/ N52K)
Special tools required:
13 5 281
Necessary preliminary tasks:
Read out fault memory of DME control unit
Switch off ignition
Remove clean air pipe
Throttle And Operation
REMOVING AND INSTALLING/SEALING THROTTLE VALVE ASSEMBLY (N52 /
N52K / N51 / N53)
Read and comply with notes on protection against electrostatic damage (ESD
protection).
Necessary preliminary tasks:
Sensor For Control Unit
REMOVING AND INSTALLING/REPLACING DIFFERENTIAL PRESSURE SENSOR
(N52 / N52K / N51)
Necessary preliminary tasks:
E90 / E91 / E92 / E93 / E87:
Remove lower section of microfilter housing.
E85 / E86 E
SEE MORE:
Axle Mounting
REMOVING AND INSTALLING/REPLACING FRONT COMPRESSION STRUT
IMPORTANT: Observe safety when raising the vehicle.
Driving without compression struts is not permitted!
Necessary preliminary tasks:
Remove underbody panelling (rear section).
Release screws (1).
Release screw (3).
Tightening torque.
Removing And Installing Complete Glass Slide/Tilt Sunroof
Special tools required:
54 1 110
Necessary preliminary tasks:
Remove roofliner.
Remove head airbag gas generator.
Open rear lid.
IMPORTANT: Two persons are required to help in removing the glass
slide/tilt sunroof.
Unfasten plug connection (1) and disconnect.
Installation:
Initialize glass
© 2019-2026 Copyright www.bmwx5info.com
