BMW X5: Transmission Shafts
BMW X5 (G05) 2019-2026 Service & Repair Manual / Transfer Box / Transmission Shafts
- Replacing Output Flange On Transfer Box At Rear (ATC 700)
- Replacing Radial Shaft Seal For Drive Flange (ATC 700)
- Replacing Radial Shaft Seal For Front Axle Output (ATC 700)
READ NEXT:
Replacing Output Flange On Transfer Box At Rear (ATC 700)
IMPORTANT: After completing work, check gear oil level, see
Replenishing /Changing
Transfer Case Oil (ATC 700) and top up if necessary.
Use only the approved gear oil in this transfer box.
NOTE:
Replacing Radial Shaft Seal For Drive Flange (ATC 700)
Special tools required:
23 0 490
27 1 460 DRIFT
IMPORTANT: After completing work, check gear oil level, see
Replenishing /Changing
Transfer Case Oil (ATC 700) and top up if necessary.
Use only a
Replacing Radial Shaft Seal For Front Axle Output (ATC 700)
Special tools required:
23 0 490
27 1 470 DRIFT
IMPORTANT: After completion of work, check transmission oil level. See
Replenishing /Changing Transfer Case Oil (ATC 700).
Use only the approved g
SEE MORE:
Checking Air Springs For Damage
NOTE: If a vehicle has been driven with depressurized air springs, the
air springs must
always be replaced.
Lift vehicle.
Air spring is OK:
when the gaiter cannot be pressed in by hand
when no visible damage (e.g. kinks, cracks, porous areas, etc.) is
discernible
when the rolling fold is unif
Cleaning Evaporator
Special tools required:
64 1 300
WARNING: When handling cleaning agent, observe following protection
measures:
Wear protective rubber gloves and protective goggles.
If cleaning agent comes into contact with eyes or skin, wash immediately
with lots of water.
IMPORTANT: To avoid dirtying vehicle
© 2019-2026 Copyright www.bmwx5info.com
