BMW X5: Time
Setting the time zone
1. "CAR".
2. "Settings".
3. "General settings".
4. "Date and time".
5. "Time zone:".
6. Select the desired setting.
Setting the time
1. "CAR".
2. "Settings".
3. "General settings".
4. "Date and time".
5. "Time:".
6. Turn the Controller until the desired hours are displayed.
7. Press the Controller.
8. Turn the Controller until the desired minutes are displayed.
9. "OK".
Setting the time format
1. "CAR".
2. "Settings".
3. "General settings".
4. "Date and time".
5. "Time format:".
6. Select the desired setting.
Automatic time setting
Depending on your vehicle's optional features, the time, date and, if needed, the time zone are updated automatically.
1. "CAR".
2. "Settings".
3. "General settings".
4. "Date and time".
5. "Automatic time setting".
READ NEXT:
Date
Setting the date
1. "CAR".
2. "Settings".
3. "General settings".
4. "Date and time".
5. "Date:".
6. Turn the Controller until the desired day is
displayed.
7. Press the Controller.
8. Make the
Driver Attention Camera
Principle
A camera that monitors driver activity is located
in the instrument cluster. The camera evaluates
the head position and eye opening and uses the data to analyze the attention of
the driver.
Speed warning
Principle
The speed warning can be used to set a speed
limit. A warning will be issued when this speed
limit is exceeded.
General information
The warning is repeated if the vehicle speed exceeds
the s
SEE MORE:
Removing And Installing/Sealing Right Cylinder Head Cover (N62/N62TU)
(cylinder bank 1 to 4)
Remove design cover, if equipped.
Unfasten acoustic cover screws. Raise acoustic cover and remove towards front.
Remove electronics box cover.
Remove electronics box seal.
These work steps are described in REPLACING CONTROL UNIT.
Remove ignition coil cover.
Remove intake
Removing And Installing/Replacing Front Active Stabilizer
WARNING: Danger of poisoning if oil is ingested/absorbed
through the skin!
Risk of injury if oil comes into contact with eyes and skin!
IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the
hydraulic
system.
Close off pipe connections with plugs.
NOTE: A film of grease o
