BMW X5: Date
Setting the date
1. "CAR".
2. "Settings".
3. "General settings".
4. "Date and time".
5. "Date:".
6. Turn the Controller until the desired day is displayed.
7. Press the Controller.
8. Make the settings for the month and year.
9. "OK".
Setting the date format
1. "CAR".
2. "Settings".
3. "General settings".
4. "Date and time".
5. "Date format:".
6. Select the desired setting.
Language
Setting the system language
1. "CAR".
2. "Settings".
3. "General settings".
4. "Language".
5. Select the desired setting.
Setting the units of measurement
Depending on the country version, you can set the units of measurement for some values, for instance consumption, distances, and temperature.
1. "CAR".
2. "Settings".
3. "General settings".
4. "Units".
5. Select the desired menu item.
6. Select the desired setting.
READ NEXT:
Driver Attention Camera
Principle
A camera that monitors driver activity is located
in the instrument cluster. The camera evaluates
the head position and eye opening and uses the data to analyze the attention of
the driver.
Speed warning
Principle
The speed warning can be used to set a speed
limit. A warning will be issued when this speed
limit is exceeded.
General information
The warning is repeated if the vehicle speed exceeds
the s
Control Display
Brightness
1. "CAR".
2. "Settings".
3. "Displays".
4. "Control display".
5. "Brightness at night".
6. Press the Controller.
7. Turn the Controller until the desired brightness
is set.
8. Press
SEE MORE:
With Parking Assistant:
side parking aid
Principle
The side protection warns of obstacles on the
side of the vehicle.
General information
The system uses the ultrasonic sensors of the
Park Distance Control PDC and the Parking Assistant.
Safety information
Warning
The system cannot serve as a substitute for the
driver's personal judgment in
Mufflers, Petrol
REPLACING REAR MUFFLER (N52K)
Special tools required:
00 2 210
31 2 220
WARNING: Scalding hazard!
Only perform these tasks after exhaust system has cooled down.
Support exhaust system with special tool 31 2 220.
Fig. 8: Identifying Special Tool (31 2 220)
NOTE: If the cutting lines are not id
