BMW X5: Driver Attention Camera
Principle
A camera that monitors driver activity is located in the instrument cluster. The camera evaluates the head position and eye opening and uses the data to analyze the attention of the driver. This system supports various vehicle assistance systems, e.g.:
- Fatigue alert.
- Steering and traffic jam assistant with Extended Traffic Jam Assistant.
Activating/deactivating
1. "CAR".
2. "Settings".
3. "General settings".
4. "Driver Attention Camera".
5. Select the desired setting.
System limits
The Driver Attention Camera may not be fully functional in the following situations:
- When the Driver Attention Camera is covered by the steering wheel rim.
- When the driver is wearing infrared impermeable sunglasses.
Trip data settings
Principle
The intervals in which the trip data will be reset can be configured.
Resetting trip data
1. "CAR".
2. "Settings".
3. "General settings".
4. "Reset trip data".
5. Select the desired setting.
READ NEXT:
Speed warning
Principle
The speed warning can be used to set a speed
limit. A warning will be issued when this speed
limit is exceeded.
General information
The warning is repeated if the vehicle speed exceeds
the s
Control Display
Brightness
1. "CAR".
2. "Settings".
3. "Displays".
4. "Control display".
5. "Brightness at night".
6. Press the Controller.
7. Turn the Controller until the desired brightness
is set.
8. Press
Notifications
Principle
The menu centrally displays all notifications arriving
in the vehicle in form of a list.
General information
The following notifications can be displayed:
Traffic messages.
Check Control
SEE MORE:
Mufflers
REPLACING REAR MUFFLER (N62TU)
Special tools required:
00 2 210
31 2 220
WARNING: Scalding hazard!
Only perform these tasks after exhaust system has cooled down.
Support exhaust system with special tool 31 2 220.
Fig. 8: Identifying Special Tool (31 2 220)
NOTE: If the cutting lines are not ide
Removing And Installing/Replacing Right Intermediate Levers (N62
From 9/03 And N62TU)
Special tools required:
11 9 470
11 9 472
11 9 473
11 9 474
11 9 475
11 9 480
11 9 490
(cylinder bank 1 to 4)
Removal of intermediate levers is described separately from installation.
Necessary preliminary tasks:
Remove servomotor from right eccentric shaft.
Remove ignition coils on cyl
© 2019-2026 Copyright www.bmwx5info.com
