BMW X5: Speed warning
Principle
The speed warning can be used to set a speed limit. A warning will be issued when this speed limit is exceeded.
General information
The warning is repeated if the vehicle speed exceeds the set speed limit again, after it has dropped below it by 3 mph/5 km/h.
Adjusting
1. "CAR".
2. "Settings".
3. "General settings".
4. "Speed warning".
5. "Warning at:".
6. Turn the Controller until the desired speed is displayed.
7. Press the Controller.
Activate/deactivate
1. "CAR".
2. "Settings".
3. "General settings".
4. "Speed warning" 5. "Speed warning".
Accept current speed as the speed warning
1. "CAR".
2. "Settings".
3. "General settings".
4. "Speed warning".
5. "Select current speed".
Activating/deactivating pop-ups
For some functions, pop-ups are displayed automatically on the Control Display. Some of these pop-ups can be activated or deactivated.
1. "CAR".
2. "Settings".
3. "General settings".
4. "Pop-ups".
5. Select the desired setting.
READ NEXT:
Control Display
Brightness
1. "CAR".
2. "Settings".
3. "Displays".
4. "Control display".
5. "Brightness at night".
6. Press the Controller.
7. Turn the Controller until the desired brightness
is set.
8. Press
Notifications
Principle
The menu centrally displays all notifications arriving
in the vehicle in form of a list.
General information
The following notifications can be displayed:
Traffic messages.
Check Control
SEE MORE:
Overview
Depending on the equipment, the following cameras
and sensors are installed in the vehicle:
Front camera.
Cameras behind the windshield.
Top view cameras.
Rearview camera.
Infrared camera.
Front radar sensor.
Radar sensors, side, front.
Radar sensors, side, rear.
Ultrasound sensors in the
Removing And Installing/Replacing Left Eccentric Shaft (N62
From 9/03 And N62TU)
(cylinder bank 5 to 8)
Necessary preliminary tasks:
Remove servomotor for left eccentric shaft.
Remove ignition coils on cylinder bank 5 to 8.
Remove spark plugs on cylinder bank 5 to 8.
Remove left cylinder head cover.
Remove left inlet and exhaust adjustment units.
Remove left inlet cams
