BMW X5: Shift Valves, Parking
BMW X5 (G05) 2019-2026 Service & Repair Manual / Automatic Transmission / Shift Valves, Parking
- Manual Emergency Release Of Transmission Lock
- Manually Unlocking Transmission Lock
- Replacing Sealing Sleeve For Transmission Housing (GA6HP26Z)
READ NEXT:
Manual Emergency Release Of Transmission Lock
In the event of a power supply interruption, e.g. flat battery or electrical
fault, the transmission lock must be
manually released, otherwise the wheel will be locked and the vehicle cannot be
move
Manually Unlocking Transmission Lock
For various tasks, it is necessary to unlock and lock the transmission lock.
This can be done from inside or underneath the vehicle.
From vehicle interior:
Refer to MANUAL EMERGENCY UNLOCKING OF TR
Replacing Sealing Sleeve For Transmission Housing (GA6HP26Z)
Special tools required:
24 2 390
IMPORTANT: After completion of work, check transmission oil level.
Use only approved transmission fluid.
Failure to comply with this requirement will result in se
SEE MORE:
Removing And Installing/Replacing RDC Receiving Antenna
Necessary preliminary tasks:
Remove front left underbody panelling.
Disconnect plug connection (1).
Gently press retaining tabs apart in direction of arrow and remove receiving
antenna (2).
Fig. 9: Removing Receiving Antenna
REMOVING AND INSTALLING/REPLACING AN RDC TRIGGER TRANSMITTER
(FRONT)
Removing And Installing/Sealing Left Cylinder Head Cover (N62/N62TU)
(cylinder bank 5 to 8)
Necessary preliminary tasks:
Remove design cover, if equipped.
Unfasten acoustic cover screws. Raise acoustic cover and remove towards
front.
Remove ignition coil cover
NOTE: For purposes of clarity, the following work steps are shown on
the engine after
it has been re
© 2019-2026 Copyright www.bmwx5info.com
