BMW X5: Removing And Installing/Replacing Airbag Module On Passenger Side
WARNING: Read and comply with safety regulations for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
- Disconnect battery negative lead.
- Remove instrument panel trim.
Unclip airbag lead with holders (1) from instrument panel.
.png)
Fig. 29: Identifying Airbag Lead
Unscrew nuts (1).
Installation:
Replace nuts.
Tightening torque.
Remove airbag module from instrument panel.
.png)
Fig. 30: Identifying Airbag Module Nuts
REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT HEAD AIRBAG (VERSION WITH SLIDE/TILT SUNROOF)
WARNING: Read and comply with safety regulations for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
A damaged head airbag must be replaced.
A damaged head airbag exhibits an impaired protective function and in extreme cases loses its protective function altogether.
NOTE: Except for the operations for Removing headliner, this task is identical to removing and installing/replacing left or right head airbag (version without slide/tilt sunroof).
REMOVING AND INSTALLING SIDE AIRBAG (FRONT SEAT)
WARNING: Observe safety regulations for handling airbag modules and pyrotechnical seat belt pretensioners.
Incorrect handling can cause airbags to trigger, resulting in serious injuries.
Necessary preliminary tasks:
- Disconnect battery negative lead.
- Partially detach backrest cover.
Remove cover (1).
.png)
Fig. 31: Identifying Airbag Cover
Unlock plug connection (1) and disconnect.
Release screws.
Installation:
Replace screws.
Tightening torque.
.png)
Fig. 32: Identifying Plug Connection
Remove airbag module (1) from inner bag (2).
Installation:
Pull inner bag (2) fully over airbag module (1) and screw brackets.
.png)
Fig. 33: Identifying Inner Bag And Airbag Module
READ NEXT:
Removing And Installing/Replacing Left Or Right Head Airbag
WARNING: Read and comply with safety regulations for handling airbag
modules and
pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
A damaged head airbag must b
SEE MORE:
Regulator
REPLACING CONTROLLER SWITCH FOR ALTERNATOR (N62, N62TU)
Necessary preliminary tasks:
Disconnect battery negative lead
Remove ALTERNATOR
Carefully insert a screwdriver between cover (1) and threaded pin.
Lever out cover (1) towards top.
Fig. 48: Inserting Screwdriver Between Cover And Threaded
Replacing Backrest Cover For Left Or Right Front Seat
Special tools required:
00 9 317.
52 0 050.
Necessary preliminary tasks:
Remove front seat.
Remove rear panel on front seat backrest.
Detach plug connection (1) by twisting from backrest frame.
Disconnect plug-in connection.
Fig. 72: Detaching Plug Connection
Release all retainers (1) on
