BMW X5: Airbag Generator-Airbag
BMW X5 (G05) 2019-2026 Service & Repair Manual / Parts And Accessories / Airbag Generator-Airbag
- Repairing Airbag Cables
- Safety Precautions And General Information
- Deactivating Front Passenger Airbags With Key-Operated Switch
- Overview Of Airbag Modules, Airbag Control Unit, Belt Tensioners
- Unlocking/Locking Airbag Plug Connections
- Removing And Installing/Replacing Airbag Module On Passenger Side
- Removing And Installing/Replacing Left Or Right Head Airbag
READ NEXT:
Repairing Airbag Cables
IMPORTANT: Only repair those cables which show visible signs of damage.
In the event of
visible damage, make sure there is only one cable repair in effect after the
repair work. If no visible damage
Safety Precautions And General Information
Safety instructions --> Safety regulations for handling airbag modules,
airbag components and pyrotechnical
seat belt tensioners.
--> Deactivation/activation pyrotechnical components.
Handling
Deactivating Front Passenger Airbags With Key-Operated Switch
WARNING: The responsibility for deactivation/activation rests with the
customer.
Depending on the occupation of the front passenger seat, the front
passenger and side airbags must be deactivated in
SEE MORE:
Piston With Ring And
REMOVING AND INSTALLING/REPLACING ALL PISTONS (N62TU)
Special tools required:
00 9 120
11 5 430
11 5 440
11 5 450
IMPORTANT: Re-install piston, conrod and bearing shells back in the
same position and in the same installation location.
Conrods and conrod bearing caps are denoted with the same
Cylinder Head Cover
As stated before, the cylinder head cover used on all of the new NG6 engines
is made from plastic. However, the design differs between the engines due to
engine equipment.
For example, the N54 engine does not use Valvetronic and therefore does not need
the accommodation for the
VVT motor. Also,
© 2019-2026 Copyright www.bmwx5info.com
