BMW X5: Final Drive With Cover
BMW X5 (G05) 2019-2026 Service & Repair Manual / Rear Axle / Final Drive With Cover
- Replacing Shaft Seal(s) For Output Shaft(s), Rear Axle Differential
- Replacing Rear Cover Gasket On Rear Differential (188K)
- Replacing Shaft Seal For Drive Flange On Rear Differential (Inserted Propeller Shaft)
READ NEXT:
Replacing Shaft Seal(s) For Output Shaft(s), Rear Axle Differential
Special tools required:
00 5 010
32 1 060
33 1 308
33 5 130
33 5 140
Necessary preliminary tasks:
Remove rear differential.
Withdraw shaft seal with special tools 00 5 010 and 32 1 060 / 33
Replacing Rear Cover Gasket On Rear Differential (188K)
IMPORTANT: To avoid leaks from the rear differential cover, do not use
a paper gasket in
cars with liquid gaskets!
To prevent the differential oil from foaming over, make sure that no remnants
of the
Replacing Shaft Seal For Drive Flange On Rear Differential (Inserted
Propeller Shaft)
Special tools required:
00 5 010
33 5 050
33 5 060
33 5 070
33 5 080
IMPORTANT: Use only approved gear oils.
Failure to comply with this instruction will result in serious damage to the
rear
SEE MORE:
Replacing Backrest Cover For Left Or Right Front Seat
Special tools required:
00 9 317.
52 0 050.
Necessary preliminary tasks:
Remove front seat.
Remove rear panel on front seat backrest.
Detach plug connection (1) by twisting from backrest frame.
Disconnect plug-in connection.
Fig. 72: Detaching Plug Connection
Release all retainers (1) on
Removing And Installing Right Cylinder Head (N62 From 9/03 And N62TU)
(cylinder bank 1 to 4)
NOTE: To remove the exhaust manifolds, the engine must be secured in
the
installation position with the special tool and then the front axle bracket
lowered.
Remove right exhaust manifold.
After removing exhaust manifolds:
Reinstall front axle bracket provisionally and remove
© 2019-2026 Copyright www.bmwx5info.com
