BMW X5: Engine Radiator
BMW X5 (G05) 2019-2026 Service & Repair Manual / Cooling System / Engine Radiator
- Removing And Installing Radiator (N52K)
- Removing And Installing/Replacing Thermostat Cartridge (N62TU/N52K)
READ NEXT:
Removing And Installing Radiator (N52K)
WARNING: Danger of scalding!
Only perform this work after engine has cooled down.
IMPORTANT: Wear protective goggles and gloves.
Necessary preliminary tasks:
Follow instructions for working on cooli
Removing And Installing/Replacing Thermostat Cartridge (N62TU/N52K)
IMPORTANT: Danger of scalding!
Only perform this work after engine has cooled down.
Necessary preliminary tasks:
Follow instructions for working on cooling system.
Draining coolant.
Remove fan c
Oil Cooler
FLUSHING OIL COOLER WITH LINES (AUTOMATIC TRANSMISSION)
Special tools required:
17 2 018 17 2 010 SET OF ADAPTERS
17 2 019 17 2 010 SET OF ADAPTERS
NOTE: Carry out the work steps listed when:
Fitt
SEE MORE:
Boost-Pressure Control
The boost pressure of the turbochargers is directly dependent on the flow of
exhaust gas which reaches the
turbocharger turbines. Both the velocity and the mass of the exhaust-gas flow
are directly dependent on engine
speed and engine load.
The engine-management system uses wastegate valves to co
Replacing Rear Left Outer Wheel Arch Section (Rear Left Side Panel
Removed)
Read contents of Body, General.
Spot-weld bonding is used on this vehicle. Observe specific procedure.
Remove or cover those vehicle components in the repair area which are
susceptible to heat or dust.
Use only approved spot-welding apparatus for repairs!
Following new body parts are required:
© 2019-2026 Copyright www.bmwx5info.com
