SEE MORE:
NOTE: If the control arm is detached from the rear axle carrier, it is
necessary after
reinstallation to carry out a wheel/chassis alignment check.
Necessary preliminary tasks:
Remove rear wheel.
Deactivate and empty air spring system.
Shown on vehicle at rear right:
Remove holders (1) from con
Special tools required:
31 3 341
31 3 351
31 3 353
WARNING: Observe the following instructions to avoid any risk of injury
by the coil
springs.
Prior to each use, check the special tools for defects, modifications
and operational reliability.
Damaged/modified special tools must not be used