BMW X5: Active seat ventilation
Principle
Integrated fans in the seat and armrest areas provide a comfortable seat temperature.
Overview
.png)
Active seat ventilation
Turning on
1. Press the button.
2. Select the ventilation level:
- Press the button once for each level.
- Turn the Controller until the desired level is reached. Press the Controller.
- Select the desired level on the touchscreen.
Highest level reached when three blue LEDs light up on the button or three blue bars are shown on the Control Display.
Turning off
Press and hold the button, until
the
LEDs turn off.
Seat climate control
Principle
The seat climate control combines the functions of the seat heating and active seat ventilation.
General information
The seat heating and active seat ventilation are operated with a common button on the climate control panel.
When both systems are active, a push of the button reduces the intensity of both functions by one level each.
The last active function or function that is configured with higher intensity will be activated directly when the system is switched on again.
When both functions with the same intensity configuration are deactivated, the system will automatically activate the seat heating.
Overview
Seat climate control
Turning on
1. Press the button.
2. Select the desired setting via the touchscreen.
One red and one blue LED each will illuminate.
Turning off
Press and hold the button, until
the
LEDs turn off.
READ NEXT:
Climate control rules
Principle
Depending on the equipment, some heating and
cooling functions can be automatically activated
depending on the outside temperature.
General information
The outside temperature at which the f
The right place for children
Safety information
Warning
Unattended children or animals in the vehicle
can cause the vehicle to move and endanger
themselves and traffic, for instance due to the
following actions:
Pressing the St
SEE MORE:
Auto Start/Stop function
Principle
The Auto Start/Stop function helps save fuel.
The system switches off the engine during a
stop, for instance in traffic jam or at traffic lights.
Drive-ready state remains switched on. The engine
starts automatically for driving off.
General information
After each engine start using the
Replacing Shaft Seal For Drive Flange On Rear Differential (Inserted
Propeller Shaft)
Special tools required:
00 5 010
33 5 050
33 5 060
33 5 070
33 5 080
IMPORTANT: Use only approved gear oils.
Failure to comply with this instruction will result in serious damage to the
rear
differential!
Necessary preliminary tasks:
Remove propeller shaft.
Remove retaining clip (1) and
