REMOVING AND INSTALLING (REPLACING) INSTRUMENT CLUSTER
IMPORTANT: Read and comply with notes on protection against
electrostatic damage (ESD
protection).
NOTE:
Comply with notes and instructions o
REMOVING AND INSTALLING/REPLACING TRIM FOR HEAD-UP DISPLAY
Special tools required:
00 9 317.
Lever out trim for head-up display (1) with special tool 00 9 317 towards top.
Fig. 2: Removing Lever
I
Chassis components
The chassis components are optimized for the
vehicle and its application range and thereby ensure
the best possible Driving Dynamics.
Two-axle self-leveling suspension
Principle
Air suspension ensures best possible driving
comfort under all load conditions. Due to a variable
adjus
(cylinder bank 5 to 8)
Necessary preliminary tasks:
Remove design cover, if equipped.
Unfasten acoustic cover screws. Raise acoustic cover and remove towards
front.
Remove ignition coil cover
NOTE: For purposes of clarity, the following work steps are shown on
the engine after
it has been re