BMW X5: General Cementing Instructions
BMW X5 (G05) 2019-2026 Service & Repair Manual / Body / General Cementing Instructions
IMPORTANT: Conform with safety precautions !
- The bonding surfaces must be kept free of all types of dirt and contamination. Avoid leaving fingerprints.
- Cleanliness is the golden rule for all bonds!
- Cleaning agent: Isopropanol, acetone or spirit
Expiry date of adhesive and primer
- The adhesive cartridge and the primer are marked with a date.
- Do not use the adhesive or primer after this date.
2-component adhesive application:
- Insert adhesive cartridge in adhesive gun, remove cap and allow some adhesive to emerge. Strip adhesive components uniformly and attach mixing tube.
- Allow approx. 1 mixer length of mixed adhesive to emerge (there must be no smearing of colors). Only then apply the mixed adhesive to one side of the bonding surface.
Adhesive disposal:
- Hardened adhesive is disposed of as normal waste.
- Empty adhesive cartridges are disposed of as normal waste.
- Non-hardened adhesives and mixtures of adhesive and solvent and the like must be disposed of as hazardous waste.
These regulations apply to the Federal Republic of Germany.
For other countries, comply with the (possibly differing) nationally applicable regulations.
READ NEXT:
Grinding Aluminum Parts
1.0 Recommended tools and equipment
To carry out outer shell grinding work by hand or machine, you must use
the recommended tools
and equipment.
The work area can be cleaned with conventional ex
Handling Airbags And Restraint Systems
1.0 Airbags and restraint systems
On vehicles with airbags and restraint systems, observe the relevant
safety instructions.
During straightening work on the body, you will be exposed to the risk
Installation Of A Cavity Seal With Cavity Foam
Sourcing reference for cavity foam.
IMPORTANT: The cavity foam may only be use for cavity sealing at the
points at which cavity
sealing is present as standard!
The following repair represents the rep
SEE MORE:
Removing And Installing/Replacing Right Exhaust Camshaft (N62/N62TU)
(cylinder bank 1 to 4)
Necessary preliminary tasks:
Remove servomotor for right eccentric shaft.
Remove ignition coils on cylinder bank 1 to 4.
Remove right cylinder head cover.
Remove spark plugs on cylinder bank 1 to 4.
Remove right inlet and exhaust adjustment units.
Remove slide rail (1)
Engine - SI Techniques (6-Cyl.)
ENGINE
VS-42 je
Bauruppe/Group: 11
welweit
Datum/Date: 02/2005
11 02 05 (130)
VACUUM SUPPLY
All models
Fig. 1: Vacuum Supply System
INTRODUCTION
Vacuum is principally used for the brake booster.
The vacuum in the inlet pipe depends on the varying engine load.
Diesel engines do not normally have a
© 2019-2026 Copyright www.bmwx5info.com
