BMW X5: Blue/Gray/White lights - Indicator/warning lights
Blue lights
High beams
.png)
High beams are switched on.
Additional information: High beams.
Drive power
.png)
Reduced drive power due to a
cold drivetrain.
Additional information: Power gauge.
Gray lights
Active Cruise Control with Stop&Go function
.png)
Indicator light is illuminated:
the system
is interrupted.
Indicator light flashes: the conditions are not adequate for the system to work or the system has been deactivated.
Additional information: Active Cruise Control with Stop&Go function.
Steering Assistant
.png)
Indicator light is illuminated:
the system
is ready.
Additional information: Steering and Lane Control Assistant.
Extended Traffic Jam Assistant
.png)
Indicator light is illuminated:
the system
is interrupted.
Additional information: Assisted Driving Plus.
White lights
Extended Traffic Jam Assistant
.png)
Indicator light is illuminated:
the system
is ready.
Additional information: Assisted Driving Plus.
READ NEXT:
Fuel gauge
Principle
The current fill level of the fuel tank is displayed.
General information
Vehicle inclination may cause the display to vary.
Additional information:
Refueling.
Display
An arrow next to the
Shift lights
Principle
The Shift lights in the instrument cluster indicate
the maximum shift point at which the best possible
acceleration can be achieved.
General information
Depending on the equipment and nation
Range
Principle
The range indicates the distance that can still be
covered with the current full tank of fuel.
General information
The estimated range available with the remaining
fuel is permanently displa
SEE MORE:
Wheel Bearings And STU
REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT SWIVEL BEARING
Necessary preliminary tasks:
Remove wheel bearing.
IMPORTANT: Secure swivel bearing against falling out.
Replacement only: Remove brake anchor plate/brake guard plate.
Remove stabilizer link from swivel bearing.
Remove upper control a
Replacing Level Switch For Dynamic Drive Fluid Reservoir
Unscrew nuts.
Remove shims.
Installation:
Replace self-locking nuts.
Fig. 162: Locating Nuts
NOTE: Raise and/or turn fluid reservoir in order to gain better access
to plug
connection.
Disconnect plug connection (1).
Turn level switch (2) through approx. 45º and remove towards bottom.
Fig. 163:
