SPRING SUPPORT SPECIFICATION
Carry out thread repair with Heli-coil thread insert.
Read and comply with tool manufacturer's instructions.
Fig. 85: Identifying Spring Support
STAMPING VEHICLE IDENTI
Read contents of Body, General.
The steel-aluminum mixed construction is used on the vehicle.
Observe specific procedure.
Remove or cover those vehicle components in the repair area which are
susc
Read contents of Body, General.
The steel-aluminum mixed construction is used on the vehicle.
Observe specific procedure.
Remove or cover those vehicle components in the repair area which are
susc
REPLACING WIRING HARNESS SECTION FOR ENGINE (N62)
Necessary preliminary tasks:
Read out DME fault memory
Disconnect battery negative lead
ENGINE BONNET/HOOD in assembly position
Remove FRESH AIR DUCT on right and if necessary on left
Remove center of ASSEMBLY PARTITION WALL
Remove intake air
IMPORTANT: To avoid leaks from the rear differential cover, do not use
a paper gasket in
cars with liquid gaskets!
To prevent the differential oil from foaming over, make sure that no remnants
of the liquid gasket are pressed into the rear differential housing.
Release screws (1).
Tightening torqu