BMW X5: Steering Wheel For Airbag Unit
BMW X5 (G05) 2019-2026 Service & Repair Manual / Steering And Wheel Alignment / Steering Wheel For Airbag Unit
- Removing And Installing/Replacing Airbag Unit
- Notes On Scrapping BMW Vehicles With Gas Generators (Central Airbag Control Unit, Airbag System)
- Safety Regulations For Handling Components With Gas Generators
- Procedure After Airbag Triggering As Result Of An Accident
READ NEXT:
Removing And Installing/Replacing Airbag Unit
WARNING: Observe the following instructions to avoid any risk of injury
by the
airbag unit.
Comply with safety regulations for handling components with gas
generators.
Do not exert any force on t
Notes On Scrapping BMW Vehicles With Gas Generators (Central Airbag
Control Unit, Airbag System)
The gas generator is a pyrotechnic component of:
Airbag module
Driver's/passenger airbag
Side airbags
Head airbag
Knee airbag
Belt pretensioner
Belt buckle tensioner
Safety battery te
Safety Regulations For Handling Components With Gas Generators
It is essential to comply with the regulations as specified in the law
relating to the use of explosives when
working on airbag units and seat belt tensioners.
Airbags, seat belt tensioners etc. are
SEE MORE:
Removing And Installing Automatic Transmission (GA6HP26Z) N62TU
Special tools required:
00 2 030
23 0 132
23 4 050
24 1 110
24 2 390
24 4 160
23 4 161
24 4 165
IMPORTANT: After completion of work, check transmission oil level.
Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious damage
to the
auto
Pressing Output Shaft Out Of Drive Flange (Wheel Hub) And Drawing In
Special tools required:
33 2 111
33 2 115
33 2 116
33 2 117
33 2 118
33 2 160
33 2 201
33 2 202
33 2 203
33 2 205
33 2 207
33 2 208
33 5 070
WARNING: Risk of injury!
It is not permitted to use the impact screwdriver to press out and draw in
the output shaft.
IMPORTANT: Risk of damage!
© 2019-2026 Copyright www.bmwx5info.com
