BMW X5 Owners & Service Manuals

BMW X5: Rocker Arm With Bearing

READ NEXT:

 Removing And Installing/Replacing Rocker Arms On Left Inlet Side (N62 From 9/03 And N62TU)

Special tools required: 11 9 470 11 9 473 (cylinder bank 5 to 8) Removal of rocker arms is described separately from installation. Necessary preliminary tasks: Remove servomotor for left eccentr

 Removing And Installing/Replacing Rocker Arms On Right Inlet Side (N62 From 9/03 And N62TU)

Special tools required: 11 9 470 11 9 473 (cylinder bank 1 to 4) Necessary preliminary tasks: Removal of rocker arms is described separately from installation. Remove servomotor for right eccen

 Valves With Springs

REMOVING AND INSTALLING/REPLACING ALL VALVES (N62) (CYLINDER HEAD REMOVED) Preliminary tasks are described in DISASSEMBLING AND ASSEMBLING CYLINDER HEAD. Remove valve springs. Remove valve stem sea

SEE MORE:

 Intake Manifold

REMOVING AND INSTALLING AIR INTAKE MANIFOLD (N52K) Necessary preliminary tasks: Remove Tension Strut Remove Intake Filter Housing Remove Ignition Coil Cover Open holder (2). Disconnect plug connection (1) under of air intake manifold. Release both crankcase breathers (3). Fig. 263: Crankcase

 Load Control

Load control of the N54 engine is effected by means of the throttle valve and the waste gate valves. The throttle valve is the primary component in this process. The wastegate valves are actuated to bring about a fine tuning of the boost pressure. At full load the throttle valve is completely op

© 2019-2026 Copyright www.bmwx5info.com