BMW X5 Owners & Service Manuals

BMW X5: Luggage Compartment

REPLACING COMPLETE REAR LUGGAGE COMPARTMENT FLOOR (TAIL PANEL REMOVED)

Read contents of Body, General.

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Spot-weld bonding is used on this vehicle. Observe specific procedure.

Use only approved spot-welding apparatus for repairs! Place vehicle on straightening bench.

Following new body parts are required:

  1. Wheel arch, rear left and right
  2. Side member, rear left and right
  3. Side member, top left and right
  4. Luggage compartment floor

Luggage Compartment
Fig. 78: Identifying Luggage Compartment Floor

Carry over the work step shown symmetrically to the other side of the vehicle.

Open weld joints in area (1).

Luggage Compartment
Fig. 79: Identifying Open Weld Joints Area

Carry over the work step shown symmetrically to the other side of the vehicle.

Open weld joints in area (1).

Luggage Compartment
Fig. 80: Identifying Open Weld Joints Area

Carry over the work step shown symmetrically to the other side of the vehicle.

Open weld joints in area (1).

Remove middle lashing rail mounting (2).

Luggage Compartment
Fig. 81: Identifying Middle Lashing Rail Mounting

View from below:

Open weld joints in area (1).

Luggage Compartment
Fig. 82: Identifying Open Weld Joints Area

Carry over the work step shown symmetrically to the other side of the vehicle.

Mark severance cut (1) in accordance with measurement a and cut.

Dimension a = 10 mm

Open weld joints in area (2).

Luggage Compartment
Fig. 83: Identifying Severance Cut Mark

Carry over the work step shown symmetrically to the other side of the vehicle.

Mark severance cut (1) in accordance with previous severance cut and cut.

Installation:

Adjust new parts to fit with straightening attachment or universal mount.

Weld in reinforcing panels at all severance cuts.

Luggage Compartment
Fig. 84: Identifying Severance Cut Mark

READ NEXT:

 Wheel Wells

 Overview Of Spring Support Repair Elements

SPRING SUPPORT SPECIFICATION Carry out thread repair with Heli-coil thread insert. Read and comply with tool manufacturer's instructions. Fig. 85: Identifying Spring Support STAMPING VEHICLE IDENTI

 Replacing Engine Carrier With Wheel Arch, Left

Read contents of Body, General. The steel-aluminum mixed construction is used on the vehicle. Observe specific procedure. Remove or cover those vehicle components in the repair area which are susc

SEE MORE:

 Crankshaft With Bearings

REPLACING CRANKSHAFT (N62/N62TU) REFERENCE CHART Operation Remove engine. Remove cylinder head (cylinder bank 1 to 4). Remove cylinder head (cylinder bank 5 to 8). Remove hub for vibration damper. Removing lower timing case cover. Removing oil pan. Remove oil pump. Removing piston. Remove

 Approach control warning with light braking function

Principle The Forward Collision Warning warns of a possible risk of collision and may brake independently. In the event of an accident, the system may reduce impact speed. General information Sensors detect the traffic situation. The system issues a two-phase warning of a possible risk of collisio

© 2019-2026 Copyright www.bmwx5info.com