REMOVING AND INSTALLING (REPLACING) CONTROL UNIT (PARK DISTANCE
CONTROL)
IMPORTANT: Read and comply with notes on protection against
electrostatic damage (ESD
protection).
Necessary preliminary tasks
INSTRUCTIONS FOR ADAPTING ADJUSTMENT UNIT FOR REVERSING CAMERA
(CORGHI KDS QUICK - ACTION CLAMP)
NOTE: The operation is described for the left-hand side; proceed in the
same way for the right-hand si
CALIBRATING REVERSING CAMERA
WARNING: Danger of injury!
Laser radiation at adjustment unit.
Do not look into the beam!
Laser class 2
As per EN 60825-1: 1994
P< or = 1 mW
Lambda = 632.8 nm
NOTE: Ca
IMPORTANT: Comply with the following topics from "Body, General":
Safety regulations.
Handling electrical/electronic equipment, airbags and restraint
systems.
A. Welding steel parts:
General information
The following procedures are used for repairs:
MAG welding (M etal A ctive G as welding)
Necessary preliminary tasks:
Remove trim panels for door pillar.
If necessary, remove air vent.
Move front seat upwards.
Release screw (1) on front seat.
Installation:
Replace screw.
Tightening torque.
Feed out belt anchor fitting (2).
Fig. 2: Identifying Seat Belt Bolts
Release screws (2).